Introduction to Performance and Advantages of Pipeline Emulsifier
The emulsion is uniformly stirred by a mass fraction of 2% emulsified fat and 98% soft water emulsion machine. Let's take a look at the performance advantages of pipeline emulsification machines.
The pipeline type emulsification machine should have good anti-corrosion and rust prevention performance, and have a lubricating effect. In pump accumulator stations, there are generally specialized emulsion emulsifying machines.
Currently, circulating mixing with a pump is simple and feasible. Fill the emulsified grease and soft water into the emulsification machine in proportion, close the gate valve, start the centrifugal pump, and circulate the mixed liquid to achieve the purpose of mixing. After the emulsification machine is stirred evenly, close the gate valve, open the gate valve, and inject the prepared emulsion into the water tank for use. Compressed air can also be used for stirring.
Radial unbalanced force of pipeline emulsification machine. When the pipeline emulsification machine works, it bears the radial hydraulic pressure on the gears and bearings. The right side of the emulsification machine is an oil suction chamber, and the left side is an oil pressure chamber.
In the oil pressure chamber, there is hydraulic pressure acting on the gear, and the oil leakage along the top of the gear has varying pressures, which are the radial unbalanced forces on the gear and bearing. The higher the hydraulic pressure, the greater the unbalanced force, which not only accelerates the wear of the bearing, reduces the life of the bearing, but even deforms the shaft, causing friction between the tooth tip and the inner wall of the emulsified body.
In order to solve the problem of radial force imbalance, in some pipeline emulsification machines, the method of opening a pressure balance tank is used to eliminate radial force imbalance, but this will increase leakage and reduce volumetric efficiency. Another pipeline type emulsification machine uses a smaller oil pressure chamber to reduce the action area of the liquid pressure on the top of the tooth to reduce the radial imbalance force, so the oil pressure port aperture of the pipeline type emulsification machine is smaller than the oil suction port aperture.
The above is all about the performance advantages of the pipeline emulsification machine. I hope it can be helpful to everyone. For more information, please pay attention to the pipeline emulsification machine manufacturer.
